QUESTIONS & ANSWERS
Assembling a SturdiBag™
1. Open front zipper.
2. Slide one fiberglass rod through sleeve in top of carrier and place
rod
end into sleeve located at rear. Bend rod just enough
to place other
end in tab located at front of carrier. Repeat with
other rod.
3. Open floor zipper.
4. Insert foam core base and close zipper.
5. Attach pad to Velcro fastener inside carrier.
How
do I wash my SturdiBag™?
Remove horizontal rods, shoulder strap,
pad and the base in the zippered compartment. Invert SturdiBag™. Actually
pull bag inside out. At this point you can reinsert the horizontal rods.
Scrub with mild soap and warm water, rinse and let air dry. Reassemble.
(machine washing will cause leather handle to shrink).
Instructions for putting together The Sturdi and Show Shelters™ Pop-Up
No bolts to drop.
No parts to lose. No Fingers to pinch. Putting together a show cage or
cat enclosure has never been quicker, lighter or safer.
To prepare for use: Simply remove the Sturdi Shelter™ Pop-Up from
handy carrying case and shake. The first section will pop into place.
Shake it again and the other
will open into place, as well.
Instantly, you're ready to show.
To
put away:
Place Show
Shelter Deluxe Pop-Up with the flat end against the floor. Put
hands on the concealed flexible supports at about the same level as the
storage pocket. Press down. The Shelter will do the rest of the work for
you by twisting the upper section as you push. The first compartment
should flatten effortlessly. Then, press again. Once the Sturdi Shelter™ Pop-Up is flat, slide into carrying case and zip to close.
Teardown only takes seconds.
Sturdi PetTent™
Assembly Instructions
1. Extend tent rods by holding down onto one end and dangling
other end down.
2. Insert tent rod into sleeve in corner and push diagonally to other
corner.
3. Repeat with other rod.
4. Place rod end into webbing on one end.
5. Hold tent and rod vertically.
6. Push down and bend rod enough to insert other end
into webbing in corner.
7. Repeat with other rod.
Washing instructions:
1. Mashine wash with cold water and mild soap.
2. Assemble tent to dry,
do not use dryer!
How
do I contact customer service?
For contact information please go to the contact page
